Every tattoo machine is a small piece of engineering, and a coil shader shows it better than most. This catalog is built around one: two coils in a black and gold pattern, a black frame, brass screws and a grip wrapped in blue. I laid it out in InDesign as a photorealistic mock-up, six pages long, and let the photographs carry the whole thing.
There is no product text in it, and that was a choice. A real catalog would list specs and parts, and this one has room for them, but I wanted to see how far the images alone could go. The file stays in InDesign, so adding pages, specs or instructions later takes very little work.

- Catalog cover: Coil Shader Tattoo Machine, a black coil machine with ornate coils and a wrapped grip over grey ink splashes
- Three product photos of the coil shader on white, its grip wrapped in blue, each from a different angle
- The coil shader from the side and from the front, needle tip toward the camera
- The coil shader taken apart, its coils, frame, screws, and washers laid out, and hands putting it back together
- The coil shader with its cord in a blue sleeve, then held in a gloved hand in front of the power supply
- A gloved hand holding the coil shader over skin marked in blue
What the six pages show
- Page 1, the cover: the coil shader sits at an angle over grey brush strokes, thin black lines and ink splatter, under the title Coil Shader Tattoo Machine in traditional tattoo lettering.
- Page 2: the assembled machine from three angles, so you can follow the frame, the coils and the needle from one side to the other.
- Page 3: two closer angles, a side view and then a front view that looks straight down the grip to the tip of the needle.
- Page 4: the machine taken apart, with every screw, washer and coil laid out flat. Below it, two hands put the frame back together while a hex key waits on the table.
- Page 5: the clip cord goes on, covered by a blue plastic sleeve, and then the machine sits in a gloved hand with the red display of the power supply behind it.
- Page 6: the needle comes down over a hand where the first lines of a design are drawn in blue.
That order follows the way I handle a coil machine. I take it apart to clean it and to understand it, I put it back together, and only then does the cord go on and the machine get ready for skin.
Each page also works on its own. Printed large, the six layouts double as a set of tattoo poster templates.
Turn the pages in the viewer above or download the PDF. More about the machines I tattoo with and how I prepare them is on the Tattoo Artist in Rome page. My 2022 post on how I started tattooing tells the earlier part of the story.




